Product description: SOBPOKS HS PRIMER is a surface tolerant multipurpose primer finish with excellent physical properties such as adhesion and toughness. It has good adhesion to a wide range of existing coatings and can be used as a primer for all areas. It can be used as a finish coat when excellent cosmetic properties are not essential. It is an ideal on-board primer because it can be overcoated with all common marine finishes. It is suitable for application to slightly corroded areas where optimum pretreatment is not practical.

Recommended use: SOBPOKS HS Primer is suitable for repair of ships in service.

Surface preparation: Best results are obtained on steel gritblasted to ISO-Sa 2.0. However, good results can also be obtained on mechanically prepared steel. Minimum standard of surface preparation recommended is ISO-St 2.All surface contamination such as dirt, grease, oil, etc. must be removed. May also be used over a wide range of existing coatings.

Packing: Two Pack Product

Safety information : Personal Protection advice and additional information can be obtained from the product Health and Safety Data Sheet which is available on request. The minimum safety precautions in dealing with this paint are:

a. Observe the precautionary notices displayed on the container.

b. Provide adequate ventilation.

c. Avoid skin contact and inhalation of spray mist.

d. If the product comes into contact with the skin, wash thoroughly with luke warm water and soap or suitable cleaner. If the eyes are contaminated, irrigate with water and seek medical advice immediately.

e. Since the product contains flammable materials, keep away from sparks and open flames. No smoking  should be permitted in the area.

Note: The manufacturer company is not responsible for any defects or results if the instructions for use and storage of products are not followed !